Also, if you use screws, make sure you locate them in an area that won't get in the way of the holes for the railroad spikes. If you do this, just be sure to use screws that are short enough that they won't go through the front of the barn board. If you don't have clamps, you could screw the scrap wood to the back of the barn board. If you have clamps, they will help greatly in keeping the two pieces of wood tightly together while the glue sets. Just apply a liberal amount of wood glue to the scrap piece of wood and centre it on the rear of the barn board. They can be used in the kitchen, bathroom shop or restaurant. I drilled two holes 16" apart from each other through the board (16" is the standard distance between wall studs) and then used my Dremel to make a sort of 'key' in the wood so it would be able to mount flush on the wall (see pics). Railroad Spikes are a functional piece of heavy duty railroad hardware with a rustic finish. The scrap board is the part that will actually be attached to the wall, so I prepared it all before gluing it to the barn board. I used some scrap pine for this as I didn't have enough barn board left to double it up. The reasoning for this is to have more material for the railroad spikes to secure to, allowing them to support more weight. Now you need to glue an extra piece of wood onto the back of your barn board to make it a bit thicker.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |